Get Clean Holes with The PorcelainPlus Speedbit

The PorcelainPlus Speedbit was specifically designed for drilling through hard surfaces such as porcelain tile, marble, granite and quartz along with ceramic tile, glass and mirrors.

Using a hand held cordless drill, simply dip the drill bit in a cup of cool water, place the drill bit on the specified mark, apply pressure, listen for a slight CRUNCH and start your drilling process.

Because the Speedbit is a scraping tool it will generate high heat. You will recognize this when the drill bit starts to release smoke.

When this starts happening, stop drilling and re-dip the drill bit into the water. This will cool the bit down and increase its longevity.  Continue this sequence until the hole is completely drilled. For best results your top drilling speed should be between 800 and 1200 RPM’s and slowed down to 500 RPM’s while breaking through the hole. This process will assure you of having clean holes and not broken tile.

Advertisements

Easier Installations With PorcelainPlus Speedbit

The PorcelainPlus Speedbit was specifically designed for drilling through hard surfaces such as porcelain tile, marble, granite and quartz along with ceramic tile, glass and mirrors. Its speed and durability distinguishes itself from other standard bits used on these surfaces.

With a specially formulated mix of metals and superior designed carbide tip, Porcelain drill bit makes your installations quicker and easier, therefore, more profitable.

More Profitable Installations

The PorcelainPlus Speedbit was specifically designed for drilling through hard surfaces such as porcelain tile, marble, granite and quartz along with ceramic tile, glass and mirrors. Its speed and durability distinguishes itself from other standard bits used on these surfaces.

With a specially formulated mix of metals and superior designed carbide tip, Porcelain drill bit makes your installations quicker and easier, therefore, more profitable.

“New Improved Carbide” 50% More Holes

Porcelain drill bit was specifically designed for drilling through hard surfaces such as porcelain tile, marble, granite and quartz along with ceramic tile, glass and mirrors.  Its speed and durability distinguishes itself from other standard bits used on these surfaces.

FEATURES:

  • Four Point Cross Step Design Spear Tip provides fast and accurate drilling.
  • No walking and rapid penetration. Tape, center punching or pilot holes are not required.
  • Specially formulated carbide tip for greater durability and clean precise holes.
  • Average of 25 seconds per hole (based on PEI Class 4 porcelain tile).
  • Drills 5+ holes per bit (based on PEI Class 4 porcelain tile).

Customer Referral Program Terms

*Terms of Program:

  • Scodd Industries must be notified of referral prior to new client ordering. This can be done by either party with a simple email (sales@porcelaindrillbit.com) or phone call (Toll Free 1-855-550-2246).
  • Free bits are earned on first purchase only from new client (Trial Pack is not considered a first purchase).
  • Maximum of 50 free drill bits per referral for each client.
  • Free drill bit sizes to match bit sizes from order (or bits at lower $ value).
  • Each new client can only be referred by one existing client.
  • Pricing to new client is based on website pricing.
  • Cannot be combined with any other offer or special

Blog at WordPress.com.

Up ↑